fbpx
Home Generator Interlock Kit for a Cutler Hammer Loadcenter Copyright-460x345-HoleOutside-IMG_6676

Copyright-460×345-HoleOutside-IMG_6676

Note how the number 10 bare copper ground wire is shaped in the rear of the generator inlet box and then wrapped around the green ground screw using the included clamp.

The hole in the wood siding was made using two spade drill bits.

First a 7/8″ bit was used to drill an 1/8″ deep hole to allow for the button connector. A 1/2″ drill bit was used to drill all the way through into the basement.

This is the location that the homeowner chose to have his portable generator sit and operate during a power outage.
The 10/3 Romex which will be entering the rear of the generator inlet box.