fbpx
Home Generator Interlock Kit for a Cutler Hammer Loadcenter Copyright-460x345-RearCoverHoles-IMG_6759

Copyright-460×345-RearCoverHoles-IMG_6759

Note how the number 10 bare copper ground wire is shaped in the rear of the generator inlet box and then wrapped around the green ground screw using the included clamp.

These are the holes that were made using the included drill bit. It is also required to scrape and file the perimeter of the holes so that the screws can make good contact for grounding of the interlock kit.

The 10/3 Romex which will be entering the rear of the generator inlet box.
A two screw metal Romex connector was used to secure the10/3 Romex to the CH circuit breaker panel.