fbpx
Home Generator Interlock Kit for a Cutler Hammer Loadcenter Copyright-460x345-TopOfLoadCenter-IMG_6703

Copyright-460×345-TopOfLoadCenter-IMG_6703

Note how the number 10 bare copper ground wire is shaped in the rear of the generator inlet box and then wrapped around the green ground screw using the included clamp.

A two screw metal Romex connector was used to secure the10/3 Romex to the CH circuit breaker panel.

These are the holes that were made using the included drill bit. It is also required to scrape and file the perimeter of the holes so that the screws can make good contact for grounding of the interlock kit.
The 10/3 Romex is stapled along the rim joist using BX staples.