fbpx
Home Generator Interlock Kit for a Cutler Hammer Loadcenter Copyright-460x613-InletBoxWire-IMG_6714

Copyright-460×613-InletBoxWire-IMG_6714

Note how the number 10 bare copper ground wire is shaped in the rear of the generator inlet box and then wrapped around the green ground screw using the included clamp.

Duct Seal was used to seal the hole from air and moisture.

The PB-30 generator inlet box comes with a factory installed green grounding pigtail. Consult article 250 in the National Electrical Code for information on grounding.
A button type Romex connector was used to prevent the 10/3 Romexfrom being pulled out. The generator inlet box was secured to the wood siding using #8 x 1-1/2 inch pan-head sheet metal screws.