fbpx
Home Generator Interlock Kit for a Cutler Hammer Loadcenter Copyright-460x613-InsideInletBox-IMG_6721

Copyright-460×613-InsideInletBox-IMG_6721

Note how the number 10 bare copper ground wire is shaped in the rear of the generator inlet box and then wrapped around the green ground screw using the included clamp.

A button type Romex connector was used to prevent the 10/3 Romexfrom being pulled out.

The generator inlet box was secured to the wood siding using #8 x 1-1/2 inch pan-head sheet metal screws.

Duct Seal was used to seal the hole from air and moisture.
An inexpensive circuit tracer comes in handy when trying to identify important circuits before you have a need to turn on the generator.