Home Installation of an Additional Wall Dimmer and New Ceiling Light Fixture MSCeilingHookWires-480x640-IMG_8759Copyrighted


This is the view inside of the ceiling with the new wire pulled in through the hole in the laminated beam.

The light fixture hook is attached to the deep octagon electrical box and the access hole in the ceiling is patched.

This hole going up into the ceiling was made with a Milwaukee 0721-20 V28 28-Volt Lithium-Ion 1/2-Inch Cordless Right Angle Drill This view is the inside of the wall through the hole in the previous photo. The big hole in the wall was needed to accommodate the big angle drill and a long auger drill bit.
Once the wires are tucked up inside the deep octagon electrical box, the canopy can be pushed up and held in place with the locknut.